TM 9-2350-277-20-3
REPLACE/REPAIR DISTRIBUTION BOX (M981A3 ONLY) Continued
0273 00
ASSEMBLY
NOTE
Connect wiring to respective terminal, as required, by tagged identification. Remove attaching
hardware, as required, to allow connection of electrical leads.
1.
Bond gasket (1) to rear cover with adhesive.
2.
Position 10 catch strikes (2) on rear cover and install 20 screws (3), new lockwashers (4) and nuts (5).
3.
Position two nut plates (6) in rear cover and install four rivets (7).
NOTE
If replacing any grommet (8), split grommet as shown before installation.
4.
Install 17 grommets (8) in their respective positions in rear cover.
5.
Position circuit breaker CB1 (9) in rear cover.
6.
Install four screws (10), eight washers (11) and (12), and four new locknuts (13).
7.
Insert bolt (14) in block E2 (15).
8.
Position block E2 (15) and insulator (16) on rear cover. Install two screws (17), washers (18), and nuts (19).
0273 00-10