DRAIN AND FILL COOLING SYSTEM Continued
FILL COOLING SYSTEM
If not filling coolant system immediately, tag master switch to warn others that engine coolant
has been drained.
Use coolant in system at all times. It will reduce corrosion in engine block and cooling system
parts. Ethylene glycol coolant will provide low temperature protection. Mix coolant and clean
water based on protection label on container.
When filling the auxiliary tank, add coolant slowly to allow trapped air to escape.
Fill system with coolant. Bring coolant level to COLD mark of filler neck.
Install coolant filler cap (4) on auxiliary tank (5).
Close coolant filler cap cover (6) on power plant grill (7).
Do not operate engine if temperature is 230
C) or above. Serious engine damage will
Start and run engine until operating temperature of 180
C) is reached.