TM 9-2350-277-20-2
REPLACE FUEL CUTOFF CONTROL CABLE ASSEMBLY Continued
0220 00
ADJUSTMENT
1.
Pull fuel cutoff control cable handle (1) to full out position.
2.
Rotate fuel control arm (2) to full clockwise position.
3.
Reset two collars (3). Place collars on each side of pin (4) and secure with two setscrews (5).
FOLLOW-THROUGH STEPS
1.
Install air intake elbow (WP 0173 00).
2.
Install drivers compartment access panel (see your -10).
3.
Lower power plant front access door (see your -10).
4.
Raise trim vane (see your -10).
END OF TASK
0220 00-7/8 blank