TM 9-2350-277-20-1
ENGINE DOES NOT CRANKContinued
0016 00
B8Y
1. Remove harness 12349813 circuit 14B plug (1) from harness
12349881 circuit 14 jack (2).
2. Measure resistance between harness 12349881 circuit 14 jack (2)
and circuit 14 plug (3).
3. Does VTM read 0 ohms?
YES
NO
B8YN
1. Install harness 12349873 plug on
harness 12349881 jack.
2. Repair harness 12349881 circuit 14
(WP 0382 00).
3. Install instrument panel
(WP 0279 00).
4. Verify no faults found.
B9Y
1. Install harness 12349813 plug on harness 12349881 circuit 14
jack.
2. Repair harness 12349881 circuit 74 (WP 0382 00).
3. Install instrument panel (WP 0279 00).
4. Verify no faults found.
CY
1. Turn MASTER SWITCH OFF.
2. Set up STE/ICE test 91 TM 9-4910-751-12&P.
3. Remove transmission controller (WP 0386 00) or (WP 0387 00).
4. Place transmission controller in SL position.
5. Measure resistance between pin M (1) and pin N (2) on controller
jack (3).
6. Does VTM read 0 ohms?
YES
NO
CYN
1. Replace transmission controller
(WP 0386 00) or (WP 0387 00).
2. Verify no faults found.
0016 00-6