COOLING FAN DRIVE ASSEMBLY REPAIR (CONTINUED)
I Remove lockwire (24), four screws (25), cover (26), and bearing gasket
(27) from cooling fan drive assembly (3). Discard gasket and lockwire.
J
NOTE
Quantity of shims will vary. Measure thickness of shims and record
information for use during assembly.
Remove six screws (28), housing (29), preformed packing (30), and
shims (31). Discard shim(s) and preformed packing.
WARNING
Use care when removing snap and retaining rings. Snap and retaining
rings are under spring tension and can act as projectiles when released
and could cause severe eye injury.
K
L
M
N
Remove retaining ring (32) and bearing (33). Discard retaining ring.
Remove drive shaft assembly (34) from fan drive housing (35).
Remove bearing (36) from drive shaft assembly (34).
Remove lockwire (37), six screws (38), and gear (39) from drive shaft
(40). Discard lockwire.
5 - 5
Change 4
TM 9-2350-267-34