TOP DOOR INNER SEALS: REMOVAL AND INSTALLATION
Test Equipment/Special Tools:
REMOVAL
Brush, wire (item 48, Appx B)
A
Materials/Parts:
B
Adhesive (item 4, Appx D)
Dry-cleaning solvent (item 19, Appx D)
c
Open and secure top doors (1, 2 and 3).
Pry up, remove and discard shim (4) and seal (5).
WARNING
Dry-cleaning solvent (PD-680) is toxic and flam-
mable. To prevent personal injury when using
PD-680, use only in a well ventilated area. Avoid
breathing vapors. If you become dizzy get fresh
air immediately and seek medical attention. Avoid
contact with eyes, skin and clothing. Use protec-
tive goggles, gloves, and clothing. If contact is
made, immediately flush with water and seek
medical attention. The flashpoint for Type I dry-
cleaning solvent is 100°F (38°C); for Type II it is
138° F (50°C). Do not use near open flame or ex-
cessive heat.
Use dry-cleaning solvent (item 19, Appx D) to clean and dry
door seal channel thoroughly. Be sure to remove all old seal par-
ticles. Use wire brush (item 48, Appx B) and rags, if necessary.
TA312963
9-58.1
Change 1
TM 9-2350-267-20