SERVICE AND PARKING BRAKE LINKAGE: REMOVAL, DISASSEMBLY, ASSEMBLY AND INSTALLATION (CONTINUED)
ASSEMBLY
A Make sure nuts (24) are screwed on rods (11 and 25).
F
Install collar (15) on end of rod (11) with new pin (14).
B
Screw rods (11 and 25) into nut (26) and tighten two nuts (24).
G Position two flat washers (12), new spring (13) and bracket (6)
on rod (11).
C Install flat washer (23), rod guide (22), two flat washers (17) and
new spring (18) on end of rod (25).
H Install handle (10) on end of rod (11) with new pin (9).
D Install new cotter pin (16) in end of rod (25).
I
Install brake linkage (p 7-17).
E
Install bell crank (3) on rod guide (22) with flat washer (21), new
lockwasher (20) and screw (19).
INSTALLATION
A Position parking brake linkage assembly (7) and install bell
crank (3) on bracket spindle (8).
B Install screw (1) and new lockwasher (2).
C Secure bracket (6) with two screws (4) and two new lockwashers
(5).
TA312841
7-18.1/(7-18.2 blank)
Change 1
TM 9-2350-267-20