(p 13-13).
APU CABLE ASSEMBLY (11671380-2): REMOVAL AND INSTALLATION
TO MANIFOLD
HEATER
REMOVAL
I
WARNING
Turn OFF MASTER switch. Disconnect battery ground
cables.
\
NOTE
Removal of left projectile rack is required (TM9-2350-
267-10).
B
Remove engine cylinder shroud door panel.
C Remove one nut, lockwasher and flat washer that secure lead assembly (1)
to manifold heater (2).
D Remove one nut, lockwasher and flat washer that secure lead assembly (1)
to preheat solenoid (3) side terminal.
E Remove cable from APU.
INSTALLATION
NOTE
Seal all exposed termials with silicone sealant adhesive
(item 5, Appx D).
Reverse removal procedures.
6-141
TA311172
TM 9-2350-267-20