HEADLIGHT SEALED-BEAM AND INCANDESCENT LAMPS: REMOVAL AND INSTALLATION
Materials/Parts:
Adhesive (item 2, Appx D)
REMOVAL
WARNING
I
Set MASTER switch OFF. Disconnect battery
ground cables.
A
Remove four screws (1) and four lockwashers (2), and cover (3)
from headlight body (4). Discard lockwashers.
B
Pull two sealed-beam lamps (5) out of body (4).
C Disconnect two electrical connectors (6) from sealed-beam lamps
(5).
D Push in blackout lamps (7), turn counterclockwise and remove.
E
Pull out and remove blackout drive reflector (8).
F
Remove and discard seal (9) from cover (3).
G Remove two gaskets (10) from two sealed-beam lamps (5).
Discard gaskets if damaged.
TA312793
6-31
Change 1
TM 9-2350-267-20