HYDRAULIC RESERVIOR AND ASSOCIATED COMPONENTS: DISASSEMBLY AND ASSEMBLY (CONTINUED)
B
c
D
E
F
G
H
Remove 14 screws (6), 14 lockwashers (7) and 14 flat washers (8). Remove
cover plate assembly (9) and gasket (10) from top of reservoir (11). Discard
lockwashers.
Remove pipe (12) and cover plate (9).
NOTE
Do step D for vehicles 1-344. For vehicles 345 and
above, go to step E.
Reach through reservoir tank cover plate opening and remove two nuts (13),
two lockwashers (14) and two washer (15) from hollw bolts of level gage
(16). Remove level gage (16) from reservoir (11). Discard lockwashers.
Unserew filter (17) from nipple (18) and remove filter (17) from inside of
reservoir (11).
NOTE
Nipple will be damaged during removal. Do not remove
unless necessary.
Remove and discard nipple (18) from inside wall of reservoir (11).
Remove five screws (19) and five flat washers (20). Carefully remove
transmitter (21) and gasket (22) from reservoir (11). Discard gasket.
Remove six screws (23) and six lockwashers (24). Carefully remove
housing assembly (25) and gasket (26) from reservoir (11). - Discard
lockwashers.
I
Unscrew housing cap (27) from housing assembly (25).
J
Disconnect electrical lead (28) from transmitter (29).
K Unscrew transmitter (29) and remove housing cap (27).
L
Remove four screws (30) and four lockwashers (31). Discard lockwashers.
M Remove lead (28) and gasket (32) from housing (25).
N Remove six screws (33), six flat washers (34), six lockwashers (35), filler
flange (36), two gaskets (37 and strainer (38). Discard lockwashers.
ASSEMBLY
A
B
C
NOTE
Apply pipe sealant (item 57, Appx D) to all male pipe
threads prior to installation.
Install strainer (38), two gaskets (37) and filler flange (36) with six new
lockwashers (35), six flat washers (34) and six screws (33).
Install lead (28) and gasket (32) on housing (25) with four screws (30) and
four new lockwashers (31).
C Screw transmitter (29) into housing cap (27).
16-4.1/(16-4.2 blank)
Change 4
TM 9-2350-267-20