14-72.2
Change 4
TM 9-2350-267-20
PERSONNEL HEATER MOUNTINGS CLAMPS AND BRACKETS: REMOVAL AND INSTALLATION (CONTINUED)
INSTALLATION
A
B
C
D
E
F
G
H
I
J
Insert four resilient mounts (25) in two supports (26).
Secure four angles (24) on two support assemblies (17 and 20) with four
screws (21), four flat washers (22) and four nuts (23).
Install lower support assembly (20) with two flat washers (19) and two
screws (18). Finger-tighten.
Install upper support-assembly (17) with two flat washers (16) and two
screws (15). Finger-tighten.
Install lower saddle bracket (14) with two flat washers (13) and two screws
(12).
Install upper saddle bracket (11) with two flat washers (10) and two screws
(9).
Tighten four nuts (23) and four screws (21).
Install powerpack (p 3-24).
Install lower clamp (8) with two straight pins (7), two flat washers (6) and
two new cotter pins (5).
Install upper clamp (4) with two straight pins (3), two flat washers (2), and
two new cotter pins (1).