DEAD-END SECTION ASSEMBLY: REMOVAL, DISASSEMBLY, ASSEMBLY AND INSTALLATION (CONTINUED),
A Thoroughly clean wear strip mounting surfaces of section (1) E
Install two pins (16) to dead-end section (1) and secure using
with dry-cleaning solvent (item 19, Appx D) and clean, dry rags
two screws (17), four flat washers (18), two new lockwashers (19)
(item 50, Appx D). Remove all particles.
and two nuts (20).
B
Roughen underside surface of new wear strips (11, 13 and 14); F
Apply sealing compound (item 53, Appx D) to threads of 20 new
apply adhesive (item 1, Appx D) to roughened side of wear strips
screws (12). Install wear strips (13 and 14) to surface of dead-
and mounting surface of section (1). Allow adhesive to dry un-
end section (1) using 20 new screws (12).
til tacky before assembly.
G Apply sealing compound (item 53, Appx D) to threads of screws
(10). Assemble bottom wear strip (11) to surface of dead-end
C Apply a thin coat of adhesive (item 4, Appx D) to new rubber
section (1) using three new screws (10).
strip (15), and to mounting surface of end section (1). Allow
adhesive to dry until tacky before installing rubber strip. In-
H Position and aline flipper block (6) with holes in dead-end sec-
stall new rubber strip (15) to mounting surface of dead-end sec-
tion (1). Drive support bar (7) into position and secure using
tion (1).
two flat washers (9) and two new cotter pins (8).
D Install latch (24) on side of dead-end section (1) using two screws I
Install two setscrews (5) to secure flipper block (6) to support
(21), two new lockwashers (23) and two flat washers (22).
bar (7). Tighten setscrews (5).
12-14.1
Change 2
TM 9-2350-267-20