• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
USING WINTERIZATlON KIT
Prestarting Procedure

TM-9-2350-267-10 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
  232    233    234    235    236  237  238    239    240    241    242  
USING WINTERIZATION KIT- Continued Operating Coolant Heater 1. 2. 3. Turn HI-LO switch (1) to HI. Hold  START-RUN-OFF  switch  (2)  at START. Indicator lamp (3) will light, indicating heater is operating. Immediately move switch (2) to RUN  position  without  hesitating  in  OFF  po- sition. TM 9-2350-267-10 4. Set switch (1) for desired rate of heat. If set at Hl, heater will automatically go on to low heat when coolant temperature reaches 190° F. If coolant temperature falls below 120° F heat control will return to high. LOW posi- tion is suitable when heater must burn for an extended period of time. NOTE After heater starts, it will continue working as long as you have fuel, electric current, air and a flow of engine coolant. Heater  will  automatically  stop  if  coolant  temperature reaches 245° F. Heater maybe restarted by following start- ing procedure (steps 1 through 4). 5. To stop heater, place switch (2) in OFF. Heater will go in purge cycle. Fuel will shut off and burning will stop when remaining fuel in heater is ex- hausted. Blower will run at low speed until heater is cool and then heater will  shut  down. 2-217







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.