97.
98.
99.
.
On left side of earner, install new
reflector (1) and new gasket (2) on hull.
Secure with two new screws (3) and new
washers (4).
Thread leads of new stop lighttail
light (5) through new gasket (6), new
bracket (7), and retained modified
guard (8).
Install stop light-tail light (5), gasket (6),
and bracket (7) on retained guard (8).
Secure with two new washers (9) and new
screws ( 10).
100.
101.
TM 9-2350-261-34
Connect circuit 23 lead to new wiring
harness (11). Connect remaining leads 21.
22-460-461, and 24 to rear main wiring
harness (12).
Install retained guard (8) with stop
lighttail light to hull. Secure with three
retained washers (13) and screws (14).
NOTE
Omit screw and washer from hole nearest
right side of new stop light-tail light.
GO TO NEXT PAGE
21-13