55. Install new right front turn signal light (1),
stud (2), and washer (3) in guard (4).
Secure with new lock washer (5) and
nut (6).
NOTE
A minimum of 1-1/2 threads should ex-
tend through nut after installing light
guard.
56.
57.
Install new guard (4) and light assembly on
hull. Secure with two new washers (7) and
screws (8).
Connect circuit 460 lead (9) to turn signal
58.
59.
60.
61.
light (1).
62.
63.
64.
65.
66.
TM 9-2350-261-34
Disconnect circuit 514 and 515 leads (10)
from left infrared headlight (11). Disconnect
circuit 19 lead (12) from blackout
headlight (13). Tag all leads for later
installation.
Unscrew nut (14) from stuffing tube (15).
Slide gasket (16) down on leads.
Use a sharp knife to slit gasket (16) at.
three holes. Pull leads free of gasket.
Discard gasket.
Use a sharp knife to slit new gasket (16) at
four holes. Install on 514 and 515
leads (10) and 19 lead (12).
Thread circuit 461 lead on harness (17)
through stuffing tube (15) and remaining
hole of new gasket (16).
Install new shell (18), new sleeve (19), and
new terminal (20) on circuit 461 lead on
harness (17).
Crimp terminal (20) on lead. Slide
sleeve (19) and shell (18) over
terminal (20).
Insert new gasket (16) in Stuffing tube (15).
Install nut (14).
Connect circuit 514 and 515 leads (10) to
infrared headlight (11). Connect circuit 19
lead (12) to blackout headlight (13).
GO TO NEXT PAGE
21-9