TM 9-2350-261-34
66. Apply a light coat of silicone paste to
70. Connect capacitor (8) lead (9) to fuel
mating surfaces of rear main wiring harness
pump (10).
circuit 402A lead (1).
71. Connect capacitor (8) lead (11) to circuit
67. Place circuit 402A lead (1) on rear main
402A lead (1).
wiring harness clamps (2).
72. Connect electrical equipment heater wiring
68. Install circuit 402A lead (1) along rear main
harness (12) to connector (13) on heater
wiring harness (3) up to forward hull
assembly (14).
grommet. Secure with nine cradles (4) and
cradle clips (5).
69. Install six clamps (2) on circuit 402A lead
(1). Secure clamps to power plant
compartment bulkhead weldnuts (6) with six
screws (7).
GO TO NEXT PAGE
13-9