TM 9-2350-261-20-4
REPLACE INVERTER DC CABLE (W6) (M1068 ONLY)
THIS WORK PACKAGE COVERS:
INITIAL SETUP:
Personnel Required
Maintenance Level
Power-Generation Equipment Repairer 52D10
Unit
Equipment Condition
Tools and Special Tools
Engine stopped (see your -10)
Carrier blocked (see your -10)
All external power disconnected (TM 11-7010-256-
12&P)
Materials/Parts
Battery ground lead disconnected (WP 0294 00)
Lockwasher (10)
Lockwasher (1)
REMOVAL
1.
Disconnect cable W6 plug (1) from power control box A1 jack J26 (2).
2.
Remove faceplate (3) on inverter housing A2 (4) by removing ten screws (5) and lockwashers (6). Discard lockwashers.
3.
Disconnect harness W6 terminal E2 (7) from terminal block TB1 (8) on inverter housing faceplate (3).
NOTE
Ground post is located on hull wall between power control box A1 and driver's station.
4.
Disconnect harness W6 terminal E1 (9) from ground post G3 (10). Remove screw (11) and lockwasher (12). Discard
lockwasher.
5.
Remove harness from carrier.