TM 9-2350-261-20-2
R E P L A C E T R A N S M I S S I O N R A N G E S E L E C T O R
DESCRIPTION
This task covers:
Remove (page 23-48).
Install (page 23-49).
INITIAL SETUP
Tools:
General Mechanics Tool Kit (Item 30, App D)
Materials/Parts:
Self-locking nut
Spring pin
Personnel Required:
Unit Mechanic
Helper (H)
References:
See your -10
Equipment Conditions:
Engine stopped/shutdown (see your 10)
Carrier blocked (see your -10)
Trim vane lowered and power plant front
access door open (see your 10)
Drivers power plant access panel removed
(page 24-25)
Air cleaner housing and element removed
(page 77)
REMOVE
4.
1. Remove screw (1) and locknut (2). Discard
locknut .
5.
2. Disconnect link (3) from arm (4).
3. Remove spring pin (5) and arm (4) from
range selector (6). Discard spring pin.
6.
Disconnect two electrical leads (7 and 8) from
circuits 74 and 74A (all carriers except
M741A1).
On M741A1 only, disconnect three electrical
leads (9, 10, and 11) from circuits 14, 74,
and 641F.
Remove three screws (12), washers (13), and
range selector (6) from drivers compartment
bulkhead.
23-48