W A R N I NG
Adjusting accelerator link-
age while the engine is
running can cause your
arm to be badly injured. Do
linkage with the engine
Remove drivers and rear power access
Loosen locknut (1). Remove screw (2) and
nut (3) from throttle link (4) and transfer
shaft (5). To decrease engine RPM at shift
point, shorten throttle link (4) by turning
rod end (6) to the right. To increase engine
RPM at shift point, lengthen throttle link
(4) by turning rod end (6) to the left.
Attach throttle link (4) to transfer shaft
with screw (2) and nut (3). Tighten
Readjust accelerator pedal stops by repeating
the following procedures:
Adjust Idle Stop (page 2337).
Adjust Upper Accelerator Pedal Detent Stop
Adjust Upper Accelerator Pedal Toe Stop
Repeat Operational Check (page 23-40).
1. Engine stopped/shutdown (see your -10).
END OF TASK