TM 9-2350-261-20-2
CLEAN, INSPECT, AND REPAIR
4.
5.
6.
7.
Check links. Replace links with cracks,
breaks, or stripped threads.
Check link clevises. Replace link clevises with
cracks or worn mounting holes.
Check clevis pins. Replace worn or grooved
clevis pins.
Check stop light tangs. Replace links with
cracked or broken tangs.
I N S T A LL
8.
9.
10.
11.
12.
Install two links (1) on steering levers and
differerential cross-shafts. Secure with four
clevis pins (2) and four new cotter pins (3).
Adjust linkage (page 23-2).
Adjust stop light switch (page 12-132).
Connect two return springs (page 23-2).
Install cress-shaft covers on power plant
compartment bulkhead (page 23-11).
FOLLOW-THROUGH STEPS
1. Install oil can bracket (page 24-237).
4. Close power plant front access door and raise
trim vane (see your 10).
2. Install air cleaner housing and element
(page 7-7)
5. Operate carrier (see your -10). Check that
the steering operates properly.
3. Install drivers power plant access panel
(page 24-25).
END OF TASK
23-15