TM 9-2350-261-20-2
159.
160.
161.
Connect circuit 37A lead (1) to right utility
outlet lead (2).
If NBC unit is installed, connect circuit
415 lead (3) to NBC unit switch.
Connect circuits 23 and 24 leads (4 and 5)
to right tail light (6).
162.
163.
164.
Install two new lockwashers (7), ground
lead (8), three clamps (9), and circuit 29
lead (10) on three weldnuts (11). Secure
with three screws (12) and flat
washers (13)
Install new lockwire (14), one screw (15),
new lockwasher (16), and ground lead (8)
on right fuel quantity sending unit (17).
Connect circuit 29 lead (10) on right fuel
quantity sending unit (17).
FOLLOW-THROUGH STEPS
1. Install rear floor plate (page 24-37).
4. Raise and lock ramp (see your -10).
2. Connect battery ground leads (page 13-2).
5. Stop/shutdown engine (see your -10).
3. Turn MASTER SWITCH ON (See your -10).
Check that electrical system works properly.
END OF TASK
12-105