TM 9-2350-261-20-2
CLEAN, INSPECT, AND REPAIR
6. Check lens. Replace cracked or chipped lens.
7. Check lamp unit. See troubleshooting
(page 393). Replace bad lamp unit.
8. Check door, body, and retainer plates.
Replace headlight if any part is missing or
damaged (page 12-3).
INSTALL
9. Install new lockwasher (1) and screw (2) in
mount (3).
CAUTION
Use care when tightening four mount
screws (5). Do not overtighten. Overtight-
ening the screws will strip the housing
threads.
10. Install new preformed packing (4), resilient
mount (3), and four screws (5) in body (6).
11. Connect lamp unit (7) to plug in lamp body
(6) with word FOG at the bottom.
12. Install lamp unit (7), retainer plate (8), and
three screws (9) in body (6).
13. Install new gasket (10), lens (11), retainer
plate (12), and four screws (13) in
door (14).
14. Install new preformed packing (15), door
(14), and four screws (16) on body (6).
FOLLOW-THROUGH STEPS
1. Install service and/or infrared headlight
(page 123).
END OF TASK
1 2 - 6