TM 9-2350-261-20-1
INSTALL
23.
16. Apply a thin even coat of sealing compound
to cleaned external threads of fittings before
installation.
24.
17. Secure nipple with jamnut (1) on power
plant rear bulkhead.
25.
18. Connect return tube (2) to nipple (1).
19. Install return tube (2) on weldnut (3). Se-
cure with clamp (4) and screw (5).
Make sure clamp is installed behind
cradle.
20. Install adapter (6) on return tube (2).
21. Install quick disconnect, half (7) on
adapter (6).
26. Position return hose (9) on four weldnuts
(16). Secure return hose (9) and two cra-
dles (17) with four clamps (18), screws (19),
and new lockwashers (20).
22. Connect quick disconnect half (8) to quick
disconnect half (7).
27. Install circuit 48B cable (21), circuit 6 cable
(22), and circuit 601 lead (23) on two
cradles (17). Secure with two clips (24).
Install return hose (9) under bracket (10)
and connect to nipple (1).
Install nipple with jamnut (11) or tee (1.1)
(M1068) on return hose (9).
Secure return hose (9) to bracket (10) with
clamp (12), screw (13), washer (14), and
new locknut (15).
NOTE
6-68
Change 4