TM 9-2350-261-20-1
REPLACE FUEL RETURN HOSES, TUBES, AND FITTINGS
(M1064 ONLY)
DESCRIPTION
This task covers:
Remove (page 6-48.9).
Install (page 6-48.12).
INITIAL SETUP
Tools:
General Mechanics Tool Kit (Item 30, App D)
Materials/Parts:
Sealing compound (Item 46, App C)
Wiping rag (Item 61, App C)
Lockwasher (5)
Lockwasher (4)
Strap (20)
Personnel Required:
Unit Mechanic
References:
See your -10
Equipment Conditions:
Engine stopped/shutdown (see your-10)
Carrier blocked (see your -10)
Ramp lowered (see your -10)
Battery ground lead disconnected (page 13-2)
Fuel tanks drained (page 6-28)
Power plant rear access panel removed
(page 24-27)
Heater duct removed (page 29-47)
Floor plates removed (page 24-38)
REMOVE
5. Remove tube assembly (6) from nipple (4).
6. Remove nut (7) and nipple (4) from tran-
sverse beam.
WARNING
Fuel flowing over a metal
surface
causes
static
electricity. This will cause
a spark unless
is grounded.
the surface
NOTE
Use wiping rags to wipe
spilled fuel.
(1) from quick
any
half
Separate quick disconnect
1.
2.
3,
4.
disconnect half (2) inside power plant rear
bulkhead.
Remove fuel return hose (3) from nipple (4).
NOTE
couplings before
half (2) from
Tag quick disconnect
removal.
Remove quick disconnect
elbow (5).
Remove elbow (5) from tube assembly (6).
GO TO NEXT PAGE
Change 2
6-48.9