TM 9-2350-261-20-1
CLEAN, INSPECT, AND REPAIR
32.
33.
34.
35.
Clean hull, retainer, shield, and pad surface
thoroughly so that metal and rubber
surfaces are clean and dry.
Check fittings. Repair or replace parts that
have stripped threads.
Check pads on bottom of tank retainer and
on hull, and rubber strips on both sides of
shield. Replace missing, cut, broken, or
cracked pads and rubber strips
(page 25-243).
Check decals. Replace decals that cannot be
read (page 25-226).
ASSEMBLE
36. Apply a thin even coat of sealing compound
to cleaned external threads of fittings before
installation.
37. Install adapter (1) in fuel tank (2).
38. Install tube (3) through adapter (1) and
guide tube into tank baffle from fuel filler
opening.
39. Install
40. Install
41. Install
Install
adapter (4) on adapter (1).
nipple (5) in fuel tank (2).
fuel drain valve (6) on nipple (5).
drain plug (7) in drain valve (6).
NOTE
If personnel heater is installed, go to
step 43.
42. Install elbow (8), shutoff valve (9), and
adapter (10) in fuel tank (2) (when
personnel heater is installed).
GO TO NEXT PAGE
6-15