TM 9-2350-261-20-1
R E P L A C E C O M B A T F I L L E R C O V E R A N D L O CK
(M113A2, M1059, M577A2, M1068, AND M901A1 ONLY)
INITIAL SETUP
Tools:
References:
General Mechanics Tool Kit (Item 30, App D)
See your -10
Materials/Parts:
Equipment Conditions:
spring pin
Engine stopped/shutdown (see your -10)
Spring pin
Ramp lowered (see your -10)
Personnel Required:
Unit Mechanic
REMOVE
1.
2.
3.
4.
NOTE
If threads on thumbscrew were previous-
ly deformed, do step 1.
Grind away deformed threads on
thumbscrew (l). Remove wing nut (2) and
thumbscrew.
Loosen wing nut (2) and thumbscrew (1)
above fuel tank inside earner.
Remove spring pin (3) and cover (4) from top
of hull. Discard spring pin.
Remove spring pin (5), washer (6), pin (7),
and spring (8) from cover (4). Discard spring
pin.
I N S T A L L
5.
NOTE
I f t h u m b s c r e w a n d w i n g n u t w e re
removed, do step 5.
Screw wing nut (2) on thumbscrew (1) and
install thumbscrew inside carrier (4). Deform
threads on thumbscrew. Tighten wing nut.
6.
7.
8.
Secure spring (8), pin (7), and washer (6) to
cover (4) with new spring pin (5).
Secure cover (4) to hull with new spring
pin (3).
Turn thumbscrew (1) into lock position.
Tighten wing nut (2).
FOLLOW-THROUGH STEPS
1. Raise and lock ramp (see your -10).
2. Stop/shutdown engine (see your -10).
END OF TASK
Change 3
6-7