TM 9-2350-261-20-1
1. Remove SUSPENSION LOCKOUT indicator cover
lens, gasket, buIb and gasket.
2. Measure voltage between indicator assembly center
contact and ground.
3. Does multimeter read less than 17 volts?
YES
1. Turn MASTER SWITCH to OFF.
2. Install SUSPENSION LOCKOUT indicator cover
lens, bulb, and gaskets.
3. Remove jumper wire.
4. Install special purpose cable circuit 509 plug on
suspension lockout pressure switch.
5. Repair lead assembly 11616349 circuit 27H
(page 14-3).
6. Verify no faults found.
1. Remove jumper wire.
2. Install special purpose
cable circuit 509 plug on
suspension lockout pressure
switch.
3. Replace SUSPENSION
LOCKOUT indicator
assembly (page 11-22).
4. Verify no faults found.
3-167