TM 9-2350-247-34
INSTALL TURN SIGNAL KIT Continued
0076 00
11. Remove and retain three wiring harnesses (1) from main wiring harness (2).
NOTE
Before drilling mounting holes, check layouts to assure centerlines are within 1/16 inch (2 mm)
tolerance of dimensions specified on illustrations. Use brackets or reflectors as templates after
locating hole pattern.
12. Locate and drill two 5/16 inch (8 mm) diameter holes in fender. Use reflector as a template. See illustration below for
reference. Repeat procedure for left side of carrier.
0076 00-5