TM 9-2350-247-34
REPAIR WINCH DRUM (M548A1) Continued
0042 00
INSTALLATION
1.
Press two new sleeve bearings (1) in drum (2) with notch of each bearing facing away from drum.
2.
Press new oil seal (3) in drum (2) with lip of oil seal facing away from drum.
3.
Install thrust ring (4) and drum (2) on drum shaft (5).
4.
Install two sliding clutch keys (6) securing drum (2) on drum shaft (5).
5.
Install endframe housing (7) on drum shaft (5) and tie rod (8). Be sure drum shaft is aligned with keyway of sliding
clutch. Check drum (2) for freedom of movement.
6.
Install new lock nut (9) on end of tie rod (8) and tighten nut (9) and nut (10) against endrame housing (7).
FOLLOW-THROUGH STEPS
1.
Fill endframe and gearcase with oil (see your -20).
2.
Install winch on carrier (see your -20).
3.
Install winch cable (see your -20).
4.
Adjust winch (see your -20).
END OF TASK
0042 00-3/4 blank