TM 9-2350-247-34
REPAIR WINCH ENDFRAME ASSEMBLY (M548A1) Continued
0041 00
INSTALLATION
1.
Install new lock nut (1) and new lock nut (2) on tie rod (3).
2.
Install tie rod (3) in gearcase housing (4) and tighten lock nut (1) to secure tie rod to housing.
3.
Install endframe housing (5) on drum shaft (6) and tie rod (3) so that drum shaft is aligned with keyway of sliding
clutch (7). Check drum for freedom of movement.
4.
Install new lock nut (8) on end of tie rod (3) and tighten lock nut (8) and lock nut (2) against endframe housing (5).
FOLLOW-THROUGH STEPS
1.
Fill endframe and gearcase with oil (see your -20).
2.
Install winch on carrier (see your 20).
3.
Install winch cable (see your 20).
4.
Adjust winch (see your 20).
END OF TASK
0041 00-8