TM 9-2350-247-20-3
REPLACE TURN SIGNAL CONTROL/MOUNT
0508 00
THIS WORK PACKAGE COVERS:
Removal (page 0508 00-1).
Installation (page 0508 00-2).
INITIAL SETUP:
Maintenance Level
Unit
Tools and Special Tools
General Mechanics Tool Kit (WP 0541 00, Item 57)
Materials/Parts
Lock nut (3)
Personnel Required
Unit Mechanic
References
See your -10
Equipment Condition
Engine stopped (see your -10)
Carrier blocked (see your -10)
REMOVAL
NOTE
Removal and installation procedures for turn signal control/mount is similar for M548A1 and
M548A3. M548A3 turn signal control does not have a bracket. M548A1 is shown.
For M548A1, do Step 4 and Step 1.
1.
Remove light lens (1) and lamp (2) from turn signal control handle (3).
2.
Disconnect harness connector (4) from turn signal control (5).
3.
Loosen clamp (6) that secures turn signal control (5) to mount (7). Remove turn signal control.
4.
Remove three lock nuts (8), six washers (9), and three screws (10) that secure mount (7) to range selector housing (11).
Remove mount. Discard lock nuts.
0508 00-1