ADJUST/ALIGN COMPRESSOR DRIVE PULLEY/BELTS (M548A1)

REPLACE COMPRESSOR DRIVE BELT GUARD (M548A1) Continued

ADJUST/ALIGN COMPRESSOR DRIVE PULLEY/BELTS (M548A1) Continued

TM-9-2350-247-20-3 Carrier Cargo Tracked 6 Ton M548A12350010969356 (EIC: AEU) M548A3 2350013696081 (EIC: AE9) Manual
Page Navigation
458

TM 9-2350-247-20-3 ADJUST/ALIGN COMPRESSOR DRIVE PULLEY/BELTS (M548A1) 0498 00 THIS WORK PACKAGE COVERS: Adjustment (page 0498 00-1). Alignment (page 0498 00-2). INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0541 00, Item 57) Personnel Required Unit Mechanic References See your -10 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) Bulkhead protector removed, if material handling kit is installed (WP 0487 00) Power plant rear access cover/door removed (see your -10) Compressor drive belt guard removed (WP 0497 00) ADJUSTMENT 1. Turn adjusting nut (1) to the right to tighten or to the left to loosen compressor drive belts (2). 2. Turn adjusting nut (1) until 5/8 inch (16 mm) deflection is obtained when about 25 lbs (11 kg) force is applied to each compressor drive belt (2) midway between compressor pulley (3) and drive pulley (4). 0498 00-1

Privacy Statement
Press Release
Contact