TM 9-2350-247-20-3
REPLACE TRANSVERSE BEAM AND CENTER SEAT PANEL (M548A1) Continued
0384 00
INSTALLATION
1.
Install two screws (1), four washers (2), and two new lock nuts (3) in transverse beam (4) to secure beam to carrier.
2.
Install three screws (5), six washers (6), and three new lock nuts (7) to secure right end of transverse beam (4) to right
seat section.
3.
Swing panel beam (8) into place. Install screw (9), two washers (10), and new lock nut (11) to secure panel beam to
transverse beam (4).
4.
Tighten screw (12) at rear end of panel beam (8).
FOLLOW-THROUGH STEPS
1.
Install primary fuel filter (WP 0176 00) or (WP 0178 00).
2.
Install air cleaner (WP 0152 00) or (WP 0159 00).
3.
Install air brake kit (WP 0495 00).
4.
Install cab cover (WP 0418 00) or (WP 0456 00).
5.
Lower center seat (see your -10).
6.
Install top access covers and grilles (WP 0390 00).
7.
Install machine gun mount kit (WP 0513 00), (WP 0514 00), or (WP 0515 00).
END OF TASK
0384 00-3/4 blank