TM 9-2350-247-20-3
REPLACE BILGE PUMP DISCHARGE TUBES AND HOSES (M548A1)
0425 00
THIS WORK PACKAGE COVERS:
Removal (page 0425 00-1).
Installation (page 0425 00-2).
INITIAL SETUP:
Maintenance Level
Unit
Tools and Special Tools
General Mechanics Tool Kit (WP 0541 00, Item 57)
Personnel Required
Unit Mechanic
References
See your -10
Equipment Condition
Engine stopped (see your -10)
Carrier blocked (see your -10)
Right seat removed (WP 0400 00)
Cab center floor plates raised (WP 0394 00)
REMOVAL
NOTE
Remove only those tubes and hoses to be replaced. Remove hoses and tubes with clamps
attached. Put clamps on replacement hoses and tubes before installation.
1.
Remove two screws (1), washers (2), and clamps (3) from tube (4).
2.
Loosen four clamps (5) that secure two hoses (6) to tube (4). Separate tube from hoses. Remove hoses from tube (7) and
bilge pump (8).
0425 00-1