REPLACE WINCH POWER TAKEOFF CONTROL (M548A1) Continued
Remove screw (11), washer (12), and clamp (13) that secure outer control cable (2) to bulkhead inside cab.
Loosen nut (14) that secures inner control cable (15) to range selector housing (16) inside cab. Pull inner control cable
out of housing. Push outer control cable (2) through opening in housing. Remove jam nut (17) and washer (18).
Remove grommet (19) from cab floor. Discard grommet.
Clean all parts.
Check outer control cable casing. Replace outer control cable that is not flexible or if it is cracked, broken, or cut.
Lubricate outer control cable with grease (WP 0128 00).
Check screws, washers, and clamps. Replace parts that have stripped threads or are cracked or deformed.