TM 9-2350-247-20-2
REPLACE PIVOT STEERING BRAKE CONTROLS/LINKAGE (M548A1) -- Continued
0369 00
NOTE
Be careful in partially removing instrument panel. Do not disconnect instrument or light
connectors. Connect any lead immediately if connector is disconnected.
3.
4.
Install pivot steering assembly (1) on mounting by rotating assembly upward and forward.
5.
Support pivot steering assembly (1). To secure pivot steering support (2) to mounting, install two washers (3) and screws
(4) through lower mounting holes.
6.
Install two tube nuts (5) and sleeves (6) to connect two tubes (7) to two elbows (8) on two master cylinders (9).
7.
Install two washers (10) and screws (11) through upper mounting holes to secure pivot steering support (2) to mounting.
FOLLOW-THROUGH STEPS
1.
2.
END OF TASK
0369 00-9/10 blank