TM 9-2350-247-20-2
REPLACE PIVOT STEERING BRAKE CONTROLS/LINKAGE (M548A1) -- Continued
0369 00
REMOVAL
NOTE
Be careful in partially removing instrument panel. Do not disconnect instrument or light
connectors. Connect any lead immediately if connector is disconnected.
1.
2.
Remove two screws (1) and washers (2) from pivot steering support (3) from upper mounting holes on mounting.
3.
NOTE
Place container under master cylinders to catch hydraulic fluid.
4.
Remove two tube nuts (4) securing two sleeves (5) and tubes (6) to two elbows (7) on master cylinders (8).
5.
Support pivot steering assembly (9) while removing two screws (10) and washers (11) from lower mounting holes on
mounting.
6.
Remove pivot steering assembly (9) from mounting by turning assembly downward and backward.