TM 9-2350-247-20-2
REPLACE TRACK TENSION ADJUSTER AND MOUNT -- Continued
0356 00
7.
Rotate mount (6). Install two screws (8).
NOTE
When using torque wrench with torque wrench adapter, torque value must be corrected.
Procedure for converting torque value is on (WP 0001 00).
8.
Tighten screw (7) and two screws (8) to 130-140 lb-ft (176-190 Nm) torque. Use adapter.
9.
Install washer (9) and screw (10) on mount (6). Tighten screw to 130-140 lb-ft (176-190 Nm) torque.
FOLLOW THROUGH STEPS
1.
Connect and adjust track (see your -10).
2.
Start engine (see your -10).
3.
Road test carrier (WP 0128 00) to check that adjuster is installed properly.
4.
Stop engine (see your -10).
END OF TASK
0356 00-4