TM 9-2350-247-20-2
REPLACE BRAKE CONTROL LINKAGE (M548A3) -- Continued
0348 00
NOTE
If connecting link (1) is disassembled, make sure that the threads of the bearing rod can be seen
in the inspection hole of the link. If no threads can be seen, remove link from upper shaft.
Loosen jam nut (2) and screw bearing rod (3) into link until threads can be seen in the
inspection hole.
13. Install connecting link (4) in connecting link (5) and secure with pin (6), washer (7), and new cotter pin (8).
14. Install connecting link (1) in clevis on shaft (9) and link (10) on shaft (11) and secure with two pins (12), washers (13),
and new cotter pins (14).
15. Connect parking brake cable stop (15) to clevis on shaft (9) and secure with pin (16), washer (17), and new cotter
pin (18).
0348 00-9