ADJUST PARKING BRAKE (M548A3) -- Continued
Hold brake pedal down until it stops. Have helper assist.
Loosen jam nut (4). Adjust control assembly cable (3) in bracket (5) until end of slot in stop (6) is against clevis pin (7).
Turn brake lever adjustment knob (2) on parking lever (1) clockwise to remove remaining slack in control assembly
cable (3). Pull lever up until it locks in place.
Release brake pedal. Brake pedal should not move. If pedal does move, repeat Steps 2 - 6 until brake pedal does not
move when parking brake is applied ON.
Apply parking brake (see your -10).
Install driver's floor plate (WP 0395 00).
END OF TASK