TM 9-2350-247-20-2
REPLACE DIFFERENTIAL AND MOUNTS (M548A1)
THIS WORK PACKAGE COVERS:
INITIAL SETUP:
Maintenance Level
Differential drained (WP 0128 00)
Machine gun mount kit removed, if installed
Unit
(WP 0513 00), (WP 0514 00), or (WP 0515 00)
Cab cover or fiberglass cab cover removed, if installed
Tools and Special Tools
(WP 0418 00) or (WP 0456 00)
General Mechanic's Tool Kit (WP 0541 00, Item 57)
Cab floor plates removed (WP 0394 00)
Beam Type Sling (WP 0541 00, Item 45)
Center seat raised (see your -10)
Remover and Replacer (WP 0541 00, Item 40)
Lifting Device, 500 lb (227 kg) capacity
Winch transfer gearcase removed (WP 0413 00)
Personnel Required
Hull bottom access cover removed (WP 0383 00)
Pivot steering brakes and brake disks removed
Unit Mechanic
Helper (H)
Heater to defroster duct removed, if personnel heater is
installed (WP 0453 00)
References
Fuel shutoff cable from engine disconnected
See your -10
Accelerator pedal link from control arm and cross-shaft
Equipment Condition
Engine stopped (see your -10)
Transmission range selector link from range selector arm
Carrier blocked (see your -10)
and cross-shaft disconnected and link removed
REMOVAL
1.
Disconnect differential high oil temperature switch lead (1) from main wiring harness.