TM 9-2350-247-20-2
REPLACE TRANSMISSION RANGE SELECTOR LINKAGE (M548A1) -- Continued
0315 00
10. Install two gear selector shaft bearings (1) with gear selector shaft (2) on bulkhead. Secure with four screws (3) and new
lock nuts (4).
11. Place selector control shift lever (5) in range selector control (6). Install range selector control shaft (7) through range
selector control and shift lever. Secure shift lever to shaft with new spring pin (8).
12. Install spring (9) and bearing (10) on range selector control shaft (7). Install range selector control arm (11) on shaft.
Secure with new spring pin (12).
13. Install range selector control (6) on bulkhead. Secure with two new lock washers (13) and screws (14).
14. Install gear selector arm (15) on gear selector shaft (2). Secure with new headless grooved pin (16).
15. Install range selector control link (17) between bearing (1) and gear selector arm (15). Secure with screw (18) and new
lock nut (19).
16. Install link boot (20) on range selector link (21). Install range selector link bearing (22) on range selector control arm
(11) and secure with screw (23) and new lock nut (24).
17. Install range selector link (21) on gear selector shaft (2). Secure with screw (25) and new lock nut (26).
FOLLOW-THROUGH STEPS
1.
Adjust transmission range selector control and linkage (WP 0315 00).
2.
Connect wiring for neutral start switch. Adjust as required (WP 0308 00).
3.
Start engine (see your -10).
4.
Check selector control shift lever for proper operation.
5.
Stop engine (see your -10).
6.
Install left center seat floor plate (WP 0394 00).
7.
Lower center seat (see your -10).
END OF TASK
0315 00-7/8 blank