ADJUST TRANSMISSION BRAKES (M548A3) -- Continued
If indicator stopped before APPLY mark, brakes are too tight. If indicator stopped past APPLY
mark, brakes need to be tightened.
Turn brake adjustment screw (11) inside transmission to adjust brakes. If indicator passed READJUST mark, turn to left
to tighten. If indicator did not reach APPLY mark, turn to right to loosen.
11. Repeat Step 9 and Step 10 as needed until indicator stops at APPLY mark.
12. Install new gasket (1) and cover (2) on transmission (3). Secure with six washers (4) and new self-locking screws (5).
Tighten screws to 156-180 lb-in (18-20 Nm) torque.
Install seat support (WP 0395 00).
Install cab floor plates (WP 0395 00).
END OF TASK