STE/ICE-R TEST 74 STARTER CIRCUIT RESISTANCE
THIS WORK PACKAGE COVERS:
Test (page 0125 00-1)
Tools and Special Tools
STE/ICE-R Test Set (WP 0541 00, Item 6)
See your -10
Engine stopped (see your -10)
Carrier blocked (see your -10)
All electrical accessories turned off (see your -10)
Fuel OFF, engine must not start (see your -10)
STE/ICE-R power hooked up (WP 0114 00)
STE/ICE-R starter circuit test hooked up (WP 0116 00)
Select TEST 74.
Perform offset test.
Press and hold TEST button until CAL appears. Release TEST button.
If VTM reads between -225 and +225, offset test passes.
If offset test fails, see TM 9-4910-571-12&P.
Press and release TEST button.
When GO appears, turn MASTER SWITCH ON and crank engine for 5 seconds or until one of the following appears on
Stop cranking and wait for message to appear.
b. A number
CIRCUIT RESISTANCE (in milliohms)
Beyond range of VTM, cannot be measured.
d. Error message
See (WP 0107 00)
Turn MASTER SWITCH OFF.
Observe VTM reading.
If VTM reading is between 5 and 27, test passes.
If reading is erratic or cannot be obtained, see TM 9-4910-571-12&P.
Return to troubleshooting task that referred you to this one.
0125 00-1/2 blank