BREAK/JOIN TRACK Continued
Install a nut on the other end of the track pin. Tighten both nuts until 2 or 3 threads show between the nuts and the ends
of the pin or about 1/8 inch (0.3 cm). Use socket wrench handle and 11/16 inch socket wrench.
Mark nut so unit maintenance can torque it properly.
Remove two track fixtures. Use adjustable wrench.
Adjust track tension (WP 0058 00).
10. Stow crowbar, track fixtures, and hammer.
11. Notify unit maintenance of track repair at earliest opportunity.
END OF TASK