MWO 9-2320-280-35-2
(23) Install 12340103-4 and 12340103-3 edge trim pieces on front and rear sections of right "B" pillar
m. LEFT "C" PILLAR REINFORCEMENT INSTALLATION.
(1) Using 12342725 rear retractor mounting bracket as a template, locate, mark, and drill two 0.468-
inch diameter holes in left "C" pillar bracket as shown in figure 61.
(2) Install rear retractor mounting bracket to left "C" pillar bracket and secure with two 453124
screws, 2436164 washers, and 9422300 nuts as shown in figure 61.
(3) Remove two plugs from left rear door jamb as shown in figure 61.
NOTE
Ensure bottom edge of template is flush to left rear door jamb prior
Clamping devices are necessary when drilling left rear door jamb
and "C" pillar.
(4) Position 12342739 template to left rear door jamb. Using template, locate and drill 0.125-inch
diameter hole in left rear door jamb as shown in figure 62.
NOTE
If 0.125-inch diameter hole drilled in step (4) passes through
existing hole in door jamb, remove template and cover hole with
tape. Repeat step (4) and scribe a 1.00-inch diameter circle
around the hole to act as a guide before performing step (5).
(5) Enlarge hole drilled in step (4) to 1.00-inch diameter as shown in figure 63.
(6) Position upper end of template in hole drilled in step (5) and aline bottom edge of template flush
to bottom left rear door jamb as shown in figure 63.
(7) Using template and GGG-D-751D drill bit, locate and drill 0.125-inch diameter hole through "C"
pillar and left rear retractor mounting bracket as shown in figure 63.
(8) Enlarge hole drilled in step (7) to 0.468-inch diameter as shown in figure 64.
(9) Install 454982 screw, two 2436164 washers, and 9422300 nut in left "C" pillar and rear retractor
mounting bracket as shown in figure 64. Tighten screw to 35-40 lb-ft (48-54 Nm).
(10) Install 12339361-2 plug and two 12339361-1 plugs in left door jamb as shown in figure 64.
n. RIGHT "C" PILLAR REINFORCEMENT INSTALLATION.
(1) Using 12342726 rear retractor mounting bracket as a template, locate, mark, and drill two 0.468-
inch diameter holes in right "C" pillar bracket as shown in figure 61.
(2) Install rear retractor mounting bracket to right "C" pillar bracket and secure with two 453124
screws, 2436164 washers, and 9422300 nuts as shown in figure 61.
(3) Remove two plugs from right rear door jamb as shown in figure 61.
28